SIMULATION BGP connectivity exists between Headquarters and both remote sites; however, Remote Site 1 cannot communicate with Remote Site 2. Configure BGP according to the topology to goals: 1. Configure R1 and R3 under the BGP process to provide reachability…
An engineer is connected to a Cisco router through a Telnet session. Which command must be issued to view the logging messages from the current session as soon as they are generated by the router? A. logging buffer B. service…
What are two characteristics of Cisco SD-Access elements? (Choose two.) A. The border node is required for communication between fabric and nonfabric devices. B. Traffic within the fabric always goes through the control plane node. C. Fabric endpoints are connected…
An engineer is configuring RADIUS-Based Authentication with EAP. MS-CHAPv2 is configured on a client device. Which outer method protocol must be configured on the ISE to support this authentication type? A. EAP-TLS B. EAP-FAST C. LDAP D. PEAP
Refer to the exhibit. Refer to the exhibit. An engineer must configure an ERSPAN tunnel that mirrors traffic from linux1 on Switch1 to Linux2 on Switch2. Which command must be added to the destination configuration to enable the ERSPAN tunnel?…
Which NTP mode must be activated when using a Cisco router as an NTP authoritative server? A. primary B. server C. broadcast client D. peer
Which activity requires access to Cisco DNA Center CLI? A. provisioning a wireless LAN controller B. creating a configuration template C. upgrading the Cisco DNA Center software D. graceful shutdown of Cisco DNA Center
By default, which virtual MAC address does HSRP group 30 use? A. 00:05:0c:07:ac:30 B. 00:00:0c:07:ac:1e C. 05:0c:5e:ac:07:30 D. 00:42:18:14:05:1e
Which A record type should be configured for access points to resolve the IP address of a wireless LAN controller using DNS? A. CISCO.CONTROLLER.localdomain B. CISCO.CAPWAP.CONTROLLER.localdomain C. CISCO-CONTROLLER.localdomain D. CISCO-CAPWAP-CONTROLLER.localdomain
Refer to the exhibit. Refer to the exhibit. Which command allows hosts that are connected to FastEthernet0/2 to access the Internet? A. ip nat inside source list 10 interface FastEthernet0/1 overload B. ip nat inside source list 10 interface FastEthernet0/2…