You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don’t have a budget to perform a hardware upgrade at this time. To optimize drops you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?
A. fwctl multik dynamic_dispatching on
B. fw ctl multik dynamic.dispatching seLmode 9
C. fw ctl multik set_mode 9
D. fw ctl miltik pq enable
|
Download Printable PDF. VALID exam to help you PASS. |
 |
Since the exam for R80.10 so the answer A
https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261#Configuration%20R77.30
“fw ctl multik set_mode 9” was the R77.30 method of enabling this feature vs using “fw ctl multik dynamic_dispatching on” on R80.10+
SK105261
Configuration on Security Gateway R80.10 and above
fw ctl multik dynamic_dispatching on
Configuration on Security Gateway R77.30
fw ctl multik set_mode 9
There is no command “fw ctl multik set_mode 9” in r.80.
I tried on real device.
Answer is A
C is correct.
To fully enable the CoreXL Dynamic Dispatcher on Security Gateway:
Run in Expert mode:
[Expert@HostName]# fw ctl multik set_mode 9
souce : https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261#CoreXL%20Dynamic%20Dispatcher
wrong, this is not for R80.10
fw ctl multik dynamic_dispatching on is the correct answer for R80.10
Ans is A if this is for R80
Run in Expert mode:
[Expert@HostName]# fw ctl multik dynamic_dispatching on
Example output:
[[email protected]:0]# fw ctl multik dynamic_dispatching on
New mode is: On
Please reboot the system
[[email protected]:0]#