Home » Cisco » 300-410 » What is the minimum time gap required by the local system before putting a BFD control packet on the wire?
What is the minimum time gap required by the local system before putting a BFD control packet on the wire?
A. Detect Mult
B. Required Min Echo RX Interval
C. Desired Min TX Interval
D. Required Min RX Interval
Correct Answer: C
Explanation/Reference:
Explanation:
Desired Min TX Interval: This is the minimum interval, in microseconds, that the local system would like to use when transmitting BFD Control packets, less any jitterapplied. The value zero is reserved.
Required Min Echo RX Interval: This is the minimum interval, in microseconds, between received BFD Echo packets that this system is capable of supporting, less anyjitter applied by the sender. If this value is zero, the transmitting system does not support the receipt of BFD Echo packets.
Reference: https://tools.ietf.org/html/rfc5880
