A server has two power supply units (PSUs) in a redundant configuration. One PSU fails. A technician replaces the failed PSU, but the server does not return to redundant power mode. What is the cause of this issue? A. Power…
A technician is sent on-site to troubleshoot a server that produced an error message during the most recent POST but then completed the POST and booted to the operating system. The user cannot remember the specific error and no entry…
A technician needs to use the iDRAC GUI to roll back a diagnostics firmware revision on a server that was updated four weeks previously. However, the replaced version cannot be found in the Firmware Rollback section on the iDRAC GUI.…
A server is configured with a RAID 5 Virtual Disk across five hard disks and one spare disk. If a hard disk failure occurs within the RAID 5 virtual disk, the spare disk needs to be online as quickly as…
A technician is remotely installing ESXi 6.0 on a PowerEdge R640 in BIOS boot mode. The system has dual internal SD cards. After the OS is installed, the system reboots and shows an error screen with the following message: "No…
A server has the following configuration: 5x 1 TB drives configured in a RAID 5 array 1x 1 TB as a global hot spare Persistent Hot Spare Slot enabled A user adds one additional 2 TB drive to the existing…
A technician needs to connect a server to a network but the network switch has only two available network ports so only two network cables can be connected. The user needs as must bandwidth as possible for their workload so…
A technician has the ISO image of an OS that they need to install on a server in a remote location. They are already logged into the iDRAC. How should the technician install the OS? A. Click Launch under the…
A technician needs to initially configure a server from a bare metal condition in the following area. Processor settings Disk configuration iDRAC network settings The technician can only reboot the server once to achieve these tasks. Where should the technician…
A technician needs to remotely update the iDRAC with Lifecycle Controller firmware. They have downloaded the latest iDRAC firmware to the management station and connected to the iDRAC GUI. What step is required to complete the update? A. After firmware…