Click the Exhibit button. The FortiAP profile used by the FortiGate managed AP is shown in the exhibit. Which two statements are correct in this scenario? (Choose two.) A. All FortiAPs using this profile will have Radio 1 scan rogue…
Your client wants to use a central RADIUS server for management authentication when connecting to the FortiGate GUI and provide different levels of access for different types of employees. Which three actions are required to provide the requested functionality? (Choose…
A customer wants to enable SYN flood mitigation in a FortiDDoS device. The FortiDDoS must reply with one SYN/ACK packet per SYN packet from a new source IP address. Which SYN flood mitigation mode must the customer use? A. SYN…
Click the Exhibit button. What are two ways to establish communication between an existing NAT VDOM and a new transparent VDOM? (Choose two.) A. Set the set ip 10.10.10.1 command to vlink21. B. Set type ppp to the vdom-link, vlink2.…
Click the Exhibit button. You have installed a FortiSandbox and configured it in your FortiMail. Referring to the exhibit, which two statements are correct? (Choose two.) A. FortiMail will cache the results for 30 minutes. B. FortiMail will wait for…
Click the exhibit button. A FortiGate device is configured to authenticate SSL VPN users using digital certificates. Part of the FortiGate configuration is shown in the exhibit. Which two statements are true in this scenario? (Choose two.) A. The authentication…
Click the Exhibit button. Central NAT was configured on a FortiGate firewall. A sniffer shows ICMP packets out to a host on the Internet egresses with the port1 IP address instead of the virtual IP(VIP) that was configured. Referring to…
An organization has one central site and three remote sites. A FortiSIEM has been installed on the central site and now all devices across the remote sites need to be monitored by the FortiSIEM. Which action would reduce the WAN…
Click the Exhibit button. Your customer is using dynamic routing to exchange the default route between two FortiGates using OSPFv2. The output of the get router info ospf neighbor command shows that the neighbor is up, but the default route…
Click the Exhibit button. Referring to the exhibit, a FortiADC is load balancing IPv4 traffic between two next-hop routers. The FortiADC does not know the IP addresses of the servers. Also, the FortiADC is doing Layer 7 content inspection and…