You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active "” Passive FortinControllers. Both FortiControllers have the configuration shown below, with the rest of the configuration set to the default values:
Config system ha set mode dual set password fortinetnse8 set group-id 5 set chassis-id 1 set minimize-chassis-failover enable set hbdev "b1" end
Both FortiControllers show Master status. What is the problem in this scenario?
A. The management interface of both FortiControllers was connected on the same work.
B. The priority should be set higher for FortiController on slot-1.
C. The b1 interface of the two FortiControllers do not see each other.
D. The chassis ID settings on FortiController on slot 2 should be set to 2.
|
Download Printable PDF. VALID exam to help you PASS. |
 |
I go for C
C : b1 default heartbeat port.