Click the Exhibit button.
The exhibit shows a full-mesh topology between FortiGates and FortiSwitches. To deploy this configuration, two requirements must be met:
-20 Gbps full duplex connectivity is available between each FortiGate and the FortiSwitches
-The FortiGate HA must be in AP mode.
Referring to the exhibit, what are two actions that will fulfill the requirements? (Choose two.)
A. Configure both FortiSwitches as peers with ICL over cable E, create one MCLAG on ports connected to cables A and C, and create another MCLAG on ports connected to cables B and D.
B. Configure the master FortiGate with one LAG and FortiLink split interface disabled on ports connected to cables A and C and make sure the same ports are used for cables B and D on the slave.
C. Configure both FortiSwitches as peers with ISL over cable E, create one MCLAG on ports connected to cables A and C, and create another MCLAG on ports connected to cables B and D.
D. Configure the master FortiGate with one LAG and FortiLink split interface enabled on ports connected to cables A and C and make sure the same ports are used for cables B and D on the slave.
|
Download Printable PDF. VALID exam to help you PASS. |
 |
I go for AB
Reasons:
1) FortiSwitch peers are using ICL, not ISL. So answer C is incorrect;
2) For MCLAG, you have to disable FortiLink Split Interface setting. So answer D is incorrect.
answer is AB.
coz MCLAG has to be disable split interface.
AD