Home » HP » HPE0-Y53 v.2 » How should the network administrator configure the FC mode for ten-GigabitEthernet 1 /0/1 on Switch 2?
Table of Acronyms
Refer to the exhibits.
Exhibit 1.
Exhibit 2.
How should the network administrator configure the FC mode for ten-GigabitEthernet 1 /0/1 on Switch 2?
A. Configure E mode on the Ten1/0/1 interface.
B. Configure NP mode on the Ten 1/0/1 interface.
C. Configure F mode on a VFC interface that is bound to the Ten 1/0/1 interface.
D. Configured NP mode on a VFC interface that is bound to the Ten1/0/1 interface.
Correct Answer: C
Explanation/Reference:
The HP FlexFabric 5900CP switch supports four operating modes. Standard mode is the default mode. FCF, NPV, and Transit modes are advanced modes.
The following applies to Switch 2: FCF (Fibre Channel Forwarder)—When a switch operates in this mode, it is called as an FCF switch. In this mode, the following HP FlexFabric 5900CP converged port connections are available:
Fibre Channel
FCoE (which is the case in this question)
HP FlexFabric 5900CP (NPIV) VF_Port to a VNP_Port on an NPV switch (which is the case of Switch1). Etc.
Note: The following applies to Switch 1: NPV/Gateway Mode—When a switch operates in this mode, it is called as an NPV (N_Port Virtualizer) switch. In this mode, the following HP FlexFabric 5900CP converged port connections are available:
Fibre Channel
FCoE (which is the case in this question)
HP FlexFabric 5900CP VF_Port to a VN_Port on a node.
HP FlexFabric 5900CP VNP_Port to a VF_Port on an FCF (NPIV) switch (this would be switch2)
References: HP FlexFabric 5900CP Solutions Configuration Guide, page 6
http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=5221896&docLocale=en_US&docId=emr_na-c04216045
Download Printable PDF. VALID exam to help you PASS.
|
|