Refer to the output shown: console (config-if-Tel/0/1) #switchport general allowed vlan add 2-6 console (config-if-Tel/0/1) #show interfaces switchport tengigabitethernet 1/0/1
Port: Tel/0/1
VLAN Membership Mode: General Mode
Access Mode VLAN: 1 (default)
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Enabled
General Mode Acceptable Frame Type: Admit All General Mode Dynamically Added VLANs: General Mode Untagged VLANs: 1-6 General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN Tagging: Disabled
Trunking Mode VLANs Enabled: All Private VLAN Host Association: none Private VLAN Mapping:
Private VLAN Operational Bindings:
Default Priority: 0
Protected: Disabled
Te1/0/1 interface must allow VLANs 2-6 and follow the 802.1Q standard.
Which change should be made to meet the requirements?
A. Add "tagged" command before VLAN ID
B. Add "tagged" at the end of the command
C. Add "trunk" at the end of the command
D. Add "802.1Q" at the end of the command
|
Download Printable PDF. VALID exam to help you PASS. |
 |