Refer to the exhibit. An expansion project added an E-Tap and Device Level Ring to interface FastEthernet1/1 of L2SW1. The administrator has looked at the logs of L2SW1 and found that FastEthernet1/1 was in an error-disabled state.Using command line access…

Refer to the exhibit. The control system depicted in the exhibit uses VLAN 300 for all of its device ports and PVST is enabled on each switch to switch connection. L2SW4 was inserted between L2SW3 and L2SW5. Links FO2 and…

Which CLI command will display IGMP snooping information in a Cisco IE2000 or Stratix 5700 switch? A. switch#show snooping ip igmp B. switch#show igmp snooping C. switch#show ip igmp snooping D. switch#show ip snooping

Refer to the exhibit. Network Faceplates have not been installed on the HMI and so you need to map a network based on information available from RSLinx. Which most accurately represents the network configuration? A ) B ) C )…

Refer to the exhibit. Which two parameters can be used to diagnose an overloaded system? (Choose two) A. Ethernet Port 1 Speed B. Module Resource Allocation Actual Rate C. Class 3 Received bytes per second D. Media Counters Alignment Errors…

Which describes a best practice rule for controlling traffic between the corporate network and the controls network? A. Outbound traffic from the control network to the corporate network and outbound traffic from the corporate network to the control network can…

Which best describes the difference between 802.11n and 802.11ac? A. 802.11ac offers more channels over more bands than 802.11n B. 802.11ac MCS 1 is about twice as fast as 802.11n MCS1 C. 802.11ac offers more modulation schemes than 802.11n D.…

It is determined that an intermittent high packet loss event is occurring within a segment of the network. The assigned task is to determine the cause. Which of these conditions should be suspected? A ) B ) C ) D…

Which configuration enables an Industrial Ethernet switch to participate in PTP clock selection and sets the priority value that would break the tie between switches with matching default criteria to 50? A. ptp mode boundaryptp priority1 10 ptp priority2 50…

You are making changes to a Stratix 5700 using an Add On Profile (AOP) and a controller which is on-line with RSLogix5000. When do the changes you have made get published to the switch? A. While online in RSLogix 5000…