How are I/O timeout and Safety I/O timeout calculated? A. An I/O connection will timeout based on the lower of 4x RPI or 100ms. Safety I/O timeout is calculated as 4xRPI. B. An I/O connection will timeout based on the…
Refer to the exhibit. Which lines represent a CIP connection being established between two devices? A. 2914 and 2915 B. 2918 and 2921 C. 2920 and 2924 D. 2937 and 2940
You have reached the limit of IPv4 IGMP groups available on a Cisco IE 3000 switch that was deployed using the Express Setup. Which CLI command will increase the number of available IPv4 IGMP groups and multicast routes from 256…
What percentage of an I/O connection would you set the RPI in order to ensure the application has the most current data? A. RPI at 50% of IO rate B. RPI at 25% of IO rate C. PI to 25%…
After commissioning several Stratix 5700 switches in a ring topology, you want to verify the installation against the network logical design. Specifically, you want to verify where the IGMP querier resides. What command can be issued in CLI to display…
Your controller has a high performance EtherNet/IP interface with port speed of >30,000 packets per second and 80% spare capacity. A new PowerFlex 753 drive will be added to the system with an RPI of 2ms and has been connected…
A ProfiNET management system operator is unable to add a ProfiNET Conformance Class B device to a SIMATIC management station. The device is connected to interface FastEthernet1/3. Based on the provided CLI output, which statement is correct? switch#show profinet lldp…
A ProfiNET management system operator is unable to see diagnostic information for a Cisco Industrial Ethernet switch that has been added to a SIMATIC management station. Based on the provided CLI output, which statement is correct? switch# show profinet status…
You are called at home at 3am by an unskilled machine operator with a suspected network related problem; the controller LEDs are all normal but the output module’s communications LED is not on. The operator has verified the cable is…
What are three Cisco best practices for running I/O control traffic in a wireless environment? (Choose three) A. 3200 packets per second and 20% bandwidth for HMI and maintenance traffic. B. 2200 packets per second and 20% bandwidth for HMI…