Which two actions are required when configuring LISP virtual machine mobility across subnets? (Choose two.) A. Filter HSRP hello messages across data centers to create an active-active HSRP setup B. Enable proxy ARP on the interfaces that allow virtual machine…

Refer to the exhibit. Which result occurs if N7K-2 fails and then recovers? A. An ARP bulk synchronization is performed by using CFS. B. N7K-2 attempts to become the primary vPC peer. C. The vPC on N7K-2 requires additional time…

Which statement about vPC loop avoidance is true? A. Up to four peer devices can be part of the same vPC domain. B. Traffic that comes from a vPC member port, and then crosses a vPC peer link, can leave…

Refer to the exhibit. The configuration belongs to which link? A. Link C on Switch4 B. Link D on Switch4 C. Link B on Switch2 D. Link A on Switch2

Refer to the exhibit. Which two features must you configure on Switch 2 to establish a VSAN trunk between Switch 1 and Switch 2? (Choose two.) A. F port B. trunk Mode On C. NP port D. Trunk Mode Auto…

Refer to the exhibit. How does Switch 1 route traffic to the Level 2 network? A. Switch 1 prefers Switch 3 as the path to the Level 2 network B. Switch 1 sends 75 percent of the traffic destined for…

Refer to the exhibit. Which statement about STP on the vPC is true? A. N7K-1 preempts N7K-2 as the STP root. B. N7K-1 appears as the STP root. C. N7K-1 and N7K-2 appear as a single STP bridge. D. N7K-2…

Refer to the exhibit. Which type of domain does the configuration create? A. Layer 3 local B. Layer 2 global C. Layer 3 global D. Layer 2 local

Refer to the exhibit. Which fabric-provided MAC address does the switch use when connecting to an end node on VSAN 9? A. 40.15.18.5e.ff.01 B. 0e.fc.00.5e.ff.01 C. 5e.ff.01.0e.fc.00 D. 40.15.18.oe.fc.00

Refer to the exhibit. What is the effect of the bind interface eth 1/16 command on the vfc130 interface? A. It attaches the physical Fibre Channel interface to the virtual Fibre Channel interface B. It attaches the FCoE interface to…