You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are…
After completing a technology refresh, you need to schedule a knowledge transfer with a customer. The customer asks you to address a number of topics during the meeting. In this scenario, which two topics would be appropriate to address? (Choose…
Click the Exhibit button. You are installing a 2-node AFF A400 switchless cluster. You have cabled the management network to the e0M port. NetApp also recommends cabling to a redundant management network switch. Referring to the exhibit, to which port…
An ONTAP cluster is installed at a secure site. The array has no access to the Internet but is managed 24/7 by onsite engineers. The customer requires that when hardware failures occur, the failures are reported to the NetApp Support…
Click the Exhibit button. You are setting up a new AFF A700 into a new rack at a customer’s site. The customer asks you to plan for simplified future growth. Referring to the exhibit, how would you satisfy this requirement?…
You have an AFF A400 cluster that is running ONTAP 9.7 software. You are asked to set up FlexCache for NFS volumes. In this scenario, which statement is correct when implementing FlexCache? A. A capacity license is required. B. A…
You are installing a new AFF A400 cluster for a customer. The customer indicates that they want to take advantage of AutoSupport On Demand. In this scenario, which AutoSupport transport protocol must you use? A. HTTP B. SMTP C. FTP…
Click the Exhibit button. You are installing a new FAS cluster. The management network must be on tagged VLAN 11 for remote administration by a service provider. Referring to the exhibit, which two ports will allow service provider access to…
Click the Exhibit button. You plan to install a new ONTAP cluster at a customer site by using the new ONTAP System Manager 9.7 GUI. Referring to the exhibit, what must you do before you provision initial storage? A. Configure…
You are adding new controllers to an existing cluster. As part of the upgrade process, you have updated the BES-53248 cluster switches. In this scenario. Which two commands would you use to verify a healthy cluster after the upgrade? (Choose…