The switches shown in the diagram. Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:
Router Ethernet port: 1st usable address
Core: second usable address
Core2: third usable address
For this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? (Choose three.)
A. Core2(config)# interface f0/0
Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B. Core2(config)# interface vlan 1
Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C. Core2(config)# line con 0
Core2(config-line)# password cisco
D. Core2(config)# line vty 0 4
Core2(config-line)# password cisco
E. Core2(config)# ip default-gateway 192.168.1.9
F. Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8
Help