Drag and Drop Question
GigSwitch1 is currently configured with a speed of 100 and Duplex is set to Auto on all interfaces. Interface 2 will be connected to GigSwitch2 which is used for all departments. Interface 1 will be used for HR traffic only.
GigSwitch1 needs to be configured with the following parameters:
* Configure the necessary protocol to prevent switching loops
* Configure GigSwitch1 with a /24 IP address for management
* Traffic across Interface 1 needs to be forced to accept and receive up to 100Mbps data at the same time
* Traffic across Interface 2 needs to be forced to use Gigabit speeds and maximum performance
Drag and drop the appropriate configurations to their corresponding requirements. All placeholders must be filled. Not all configurations will be used.
Exam N10-008: CompTIA Network+Free dumps for N10-008 in PDF format.High quality N10-008 PDF and software. VALID exam to help you pass. |
 |
