Home » Network Appliance » NS0-180 » Which three parameters should be selected?
Click the Exhibit button.
You are asked to install a 6-node cluster running clustered Data ONTAP 8.3 using Cisco switches. The customer has installed Config Advisor on a PC on their network and has asked you to help them collect data.
Referring to the exhibit, which three parameters should be selected? (Choose three.)
A. Enable management switch connections
B. Switchless
C. Enable cluster switch connections
D. Cisco NX5010/NX5020/5596/5596T
E. NetApp CN1610/CN1601
Correct Answer: ADE
Explanation/Reference:
In the clustered Data ONTAP profile, you can choose any one of the following (based on the network switch used):
*Cisco NX5010/5020/5596 (Cisco switches is used in this question)
*NetApp CN1610/CN1601
To verify clustered configurations, you should ensure the following:
*The data is collected from cluster switches, management switches, and a controller.
Etc.
Reference: Config Advisor 3.2. Installation and Administration Guide, page 21
|
Download Printable PDF. VALID exam to help you PASS.
|
 |
You can select Cisco or NetApp D or E not both, and since the Question specifies Cisco, E would not be a correct answer.