To fully enable Dynamic Dispatcher on a Security Gateway:
A. run fw ctl multik set_mode 9 in Expert mode and then Reboot.
B. Using cpconfig, update the Dynamic Dispatcher value to "full" under the CoreXL menu.
C. Edit/proc/interrupts to include multik set_mode 1 at the bottom of the file, save, and reboot.
D. run fw multik set_mode 1 in Expert mode and then reboot.
here you must use Answer a
but the correct answer is for 80.10
to fully enable dynamic dispatcher on a security gateway, run the following command in Expert mode and then reboot:
fw ctl multik dynamic_dispatching on
CCSE training guide page 418