Which command you enter on a switch to display the ip address associated with connected devices?

4 thoughts on “Which command you enter on a switch to display the ip address associated with connected devices?”

1. answer is A

   just tested

   Reply

2. Sock#show cdp neighbors detail
   ————————-
   Device ID: Shoe
   Entry address(es):
   IP address: 10.1.2.2
   Platform: Linux Unix, Capabilities: Router Source-Route-Bridge
   Interface: Serial2/0, Port ID (outgoing port): Serial2/0
   Holdtime : 174 sec

   Version :
   Cisco IOS Software, Linux Software (I86BI_LINUX-ADVENTERPRISEK9-M), Version 15.5(2)T, DEVELOPMENT TEST SOFTWARE
   Technical Support: http://www.cisco.com/techsupport
   Copyright (c) 1986-2015 by Cisco Systems, Inc.
   Compiled Thu 26-Mar-15 07:36 by prod_rel_team

   advertisement version: 2
   Management address(es):
   IP address: 10.1.2.2

   ————————-
   Device ID: IOU1
   Entry address(es):
   Platform: Linux Unix, Capabilities: Router Switch IGMP
   Interface: Ethernet0/0, Port ID (outgoing port): Ethernet0/3
   Holdtime : 129 sec

   Version :
   Cisco IOS Software, Linux Software (I86BI_LINUXL2-ADVENTERPRISEK9-M), Version 15.2(CML_NIGHTLY_20151103)FLO_DSGS7, EARLY DEPLOYMENT DEVELOPMENT BUILD, synced to FLO_DSGS7_POSTCOLLAPSE_TEAM_TRACK_DSGS_PI5
   Technical Support: http://www.cisco.com/techsupport
   Copyright (c) 1986-2015 by Cisco Systems, Inc.
   Compiled Wed 04-Nov-15 02:31 by mmen

   advertisement version: 2
   VTP Management Domain: ”
   Native VLAN: 1
   Duplex: half

   Total cdp entries displayed : 2

   Reply

3. show cdp neighbors detail and show cdp entry commands displays additional information about the neighboring devices that include network-layer protocol information and version.

   Reply

4. SW1#show cdp neighbors detail
   ————————-
   Device ID: SW2
   Entry address(es):
   Platform: Cisco 3725, Capabilities: Router Switch IGMP
   Interface: FastEthernet1/15, Port ID (outgoing port): FastEthernet1/15
   Holdtime : 141 sec

   Version :
   Cisco IOS Software, 3700 Software (C3725-ADVENTERPRISEK9-M), Version 12.4(15)T14, RELEASE SOFTWARE (fc2)
   Technical Support: http://www.cisco.com/techsupport
   Copyright (c) 1986-2010 by Cisco Systems, Inc.
   Compiled Tue 17-Aug-10 12:08 by prod_rel_team

   advertisement version: 2
   VTP Management Domain: ”
   Native VLAN: 1
   Duplex: full

   SW1#show cdp neighbors
   Capability Codes: R – Router, T – Trans Bridge, B – Source Route Bridge
   S – Switch, H – Host, I – IGMP, r – Repeater

   Device ID Local Intrfce Holdtme Capability Platform Port ID
   SW2 Fas 1/15 123 R S I 3725 Fas 1/15

   I dont see IP in none of this commands.

   Reply