What could be an issue?

Hotspot Question – RIPv2 Troubleshooting

– Router R1 connects the main office to internet, and routers R2 and R3 are internal routers
– NAT is enabled on Router R1
– The routing protocol that is enabled between R1, R2 and R3 is RIPv2
– R1 sends default route into RIPv2 for internal routers to forward internet traffic to R1
– Server1 and Server 2 are placed in VLAN 100 and 200 respectively, and are still running on stick Configuration with router R2.
You have console access on R1, R2, R3 and L2SW1 devices.
Use only show commands to troubleshoot the issues.
Server1 and Server2 are unable to communicate with the rest of the network. Your initial check with system administrators shows that IP address settings are correctly configured on the server side. What could be an issue?
A. The VLAN encapsulation is misconfigured on the router subinterfaces.
B. The Router is missing subinterface configuration.
C. The Trunk is not configured on the L2SW1 switch.
D. The IP address is misconfigured on the primary router interface.

Pass Cisco CCNA 200-301 Exam in First Attempt FULL Printable PDF and Software. VALID exam to help you pass.